Impulse g+ series 2 manual

IMPULSE®G+ VG+ Series 4 Instruction Manual - August ii Disclaimer of Warranty Magnetek, hereafter referred to as Company, assumes no responsibility for improper programming of a drive by untrained personnel. A drive should only be programmed by a trained technician who has read and understand the contents of this manual. Since we have been providing outstanding AC drive repair service for our customers throughout the U.S. and abroad, and our highly skilled technical staff has experience performing repair of Magnetek AC drives from every application imaginable including HVAC, conveyor, fan pump, washer, CNC spindle, crane, extruder, elevator and many more. For IMPULSE•G+/VG+ Series 2 drives: 1. With power off, remove the keypad from the front corner of the drive 2. Connect the female connector into the drive’s keypad receptacle 3. Attach the DB-9 connector end of the cable to the serial communication port on the PC For IMPULSE•P3 Series 2 and IMPULSE•G+/VG+ Series 3 drives: 1.

If you need a Series 2 manual, first determine which software version is in your IMPULSE®.G+ Series 2 or IMPULSE®.VG+ Series 2 drive, and complete the following steps: Power up the drive. The drive will display parameter U, "Output Frequency" on line one. WARNING 1. Read this user manual in its entirety before installing IMPULSE®•LINK 5 Software or operating the IMPULSE®•G+/VG+ Series 4, IMPULSE®•G+/VG+ Series 3, and/or the IMPULSE®•G+ Mini. 2. DO NOT connect or disconnect wiring, or perform signal checks while the electrical power is turned ON. 3. IMPULSE®•G+/VG+ Series 4 Analog Input Installation Manual - August 1. Preface and Safety Magnetek manufactures products used as components in a wide variety of industrial systems and equipment. The selection and application of Magnetek products remain the responsibility of the equipment manufacturer or end user.

IMPULSE®•G+/VG+ Series 4 Sway Control System - Series 2 November 6 Product Overview Introduction to Sway Control System – Series 2 Sway Control System Series 2 (SCS-S2) is a method to greatly reduce the amount of unwanted swing when moving suspended loads. It works by point-mass theory such that a suspended load behaves as a pendulum. IMPULSE®•G+/VG+ Series 4 Analog Input Installation Manual - August 1. Preface and Safety Magnetek manufactures products used as components in a wide variety of industrial systems and equipment. The selection and application of Magnetek products remain the responsibility of the equipment manufacturer or end user. IMPULSE•G+ Mini Advanced Instruction Manual - November IMPULSE•G+ Mini General Specifications V Class V Class V and V Classes Specification Specification Values and Information for Each V-Class Model Rated current (A)