Heron interface probe manual

Interface meters are specialized water level meters designed to measure the depth and level of anhydrous phase fluids, both dense and light (DNAPL LNAPL) and water with different audio and visual indicators. A dirty or scratche probe lens aggravates this problem. Removing The Probe This requires two wrenches a 1/2"AF and 9/16"AF. When the knurled nut has been loosened the link may be still tight in the probe. Gently separate the link from the probe by hand. Care must be taken to avoid either breaking the wires while removing the probe or. Description. The www.doorway.ru Oil/Water Interface meter is used to measure the interface level between two liquids in the same tank, vessel, well or www.doorway.ru dissimilar density of two liquids means the lower density, non-conductive product (LNAPL) will float on top of the higher density, conductive liquid (water).Denser products will tend to sink (DNAPL), creating a layer under the water.

Heron F, Oil/Water Interface Probe ' Tape. The www.doorway.ru Oil/Water Interface meter is used to measure the interface level between two liquids in the same tank, vessel, well or aquifer. The dissimilar density of two liquids means the lower density, non-conductive product (LNAPL) will float on top of the higher density, conductive liquid. The Heron HL oil / water interface meter is used to accurately measure the thickness of floating product (LNAPL) above the water table. It will also detect and measure sinking layers of DNAPL. The HL with its slim probe 5/8in (13mm), is ideal for wells, piezometers and direct push equipment as narrow as 3/4in (19mm) ID. The www.doorway.ru's 5/8 inch (16 mm) field replaceable probe is fully submersible and leak proof up to 1, ft ( m). It is 7 inches ( mm) in length. A flexible, durable linking device connects the probe to the tape and the lens at the probe end is protected by a stainless steel shield. An emitter is capable of sensing, with an infrared beam.

allow the probe to allimatise in the well or lower the probe into the water, the n take readings. A dirty or scratche probe lens aggravates this problem. Removing The Probe This requires two wrenches a 1/2"AF and 9/16"AF. When the knurled nut has been loosened the link may be still tight in the probe. Gently separate the link from the probe by. Heron Instruments Catalogue. SEE CATALOGUE. Oil/Water Interface Meter Manual. Certification. Conductivity, Temperature Water Level Meter Resources. MODEL. Heron Canada’s customer service (Jancis (my contact) especially) has been a life saver. The technical knowledge, service, and everything really couldn’t be more recommended by me. As far as I am concerned, Heron SET the industry standard for what to expect from a company. Keep up the good work.